How to choose low-carbon lighting for a family home
Lights run for hours in every room of a family home. Here is which bulbs to buy, how to use daylight, and how to get kids to turn things off.
Lights on in every room. The hall light burns all night for the kid who is scared of the dark. The bathroom light is on with nobody in it. The kitchen light is on at noon on a sunny day.
Lighting is not the biggest energy user in a home. Heating, cooling, and hot water use more. But lights run for hours every day in every room, and they are one of the cheapest and fastest things to fix. The carbon comes from the electricity the bulbs use and, to a smaller degree, from making and throwing away the bulbs themselves.
This article covers which bulbs to buy, which to leave in place for now, how to use daylight, and how to get kids to turn things off.
Switch to LED bulbs
An LED bulb uses a small fraction of the electricity of an old incandescent bulb for the same amount of light. It lasts many years instead of months. It runs cool, which helps in summer. It is the single biggest lighting change you can make.
Do not throw out working bulbs to make the switch. Replace bulbs as they burn out, starting with the ones that run the longest each day. In most homes that means the kitchen, the living room, the hallway, and any outdoor light that stays on at night.
If you have compact fluorescent bulbs (the twisted ones), keep using them until they fail. They use far less than incandescent. When they go, take them to a hazardous waste drop-off, since they contain a small amount of mercury. Many hardware stores take them.
Read the box
Bulb boxes carry more information than they used to. A few things matter:
- Lumens, not watts, tell you how bright the bulb is. An old 60-watt bulb gives about 800 lumens. Match the lumens to the old bulb, not the watts.
- Color temperature is listed in Kelvin. Lower numbers (2700K) give a warm, yellow light like an old bulb. Higher numbers (4000K and up) give a whiter, cooler light. Warm works well in bedrooms and living rooms. Cooler light suits a kitchen counter or a desk.
- Check that the bulb says it works with a dimmer if you have one. A non-dimmable LED on a dimmer switch flickers and fails early.
- Look for the ENERGY STAR label if you want a bulb that has been tested for how long it lasts and how its light holds up.
- Check the base and shape. Most bulbs use the standard screw base, but many fixtures use a small candle base or a pin base.
Buy a two-pack of one bulb and try it before you buy a box of twelve. The light that looks fine in the store can look wrong in your living room.
Use daylight first
The lowest-carbon light is the one coming through the window. Open curtains and blinds in the morning. In winter, close them at dusk to hold the heat in. Move the kids’ play area, the homework spot, and the reading chair next to a window. Trim the shrub that blocks the kitchen window.
Light-colored walls and ceilings bounce daylight deeper into a room. A mirror across from a window does the same. Clean windows let in more light than dirty ones, and kids can help with the inside.
In summer, daylight and heat come together, so this works best on the north and east sides of the house. The summer cooling article covers how to balance light and shade on the sunny side.
Light the task, not the room
A ceiling fixture lights the whole room so one person can read in a corner. A small lamp next to the chair does the same job with one small bulb.
- Put a reading lamp next to the couch and the beds.
- Use an under-cabinet strip or a small lamp on the kitchen counter for making lunches after dark.
- Give each kid a desk lamp for homework so the overhead light can stay off.
- Use a low night light in the hall instead of leaving the bathroom light on all night. Pick one with a sensor so it comes on only in the dark.
Fewer, better-placed lights also make a room feel calmer at bedtime.
Turn things off
The bulb that uses no power is the one that is off. Kids are not good at this, and most adults are not either. A few things help:
- Put a sticker or a small sign at eye level for the kids in rooms they forget. A colored dot on the switch is enough for a preschooler.
- Give one child the job of lights-out before you leave the house. Rotate the job each week.
- Install a motion sensor switch in the bathroom, the laundry room, the closet, and the garage. These rooms are where lights get left on most.
- Use a timer or a dusk-to-dawn sensor on outdoor lights so they turn off at bedtime or at sunrise.
- Put the porch light on a motion sensor instead of leaving it on all night.
A smart bulb or switch lets you turn things off from your phone and set schedules. Note that smart bulbs draw a little power all the time to stay connected, so they fit best on lights that are on for long stretches anyway. The standby power article explains this trade-off.
Fix the fixtures you have
You do not need new light fixtures to get low-carbon light. A new LED bulb in an old fixture works. A ceiling fixture with three sockets can take three low-lumen LED bulbs instead of three bright ones, or two bulbs instead of three.
Dust the bulbs and the glass shades a few times a year. Dust and grime cut the light a fixture gives, so you turn on more lights to make up for it.
If a fixture does need replacing, pick one that takes a standard bulb rather than one with a built-in LED panel. When the built-in LED fails, the whole fixture goes in the trash. A fixture with a replaceable bulb lasts for decades. The same thinking applies to any product you buy.
Holiday and outdoor lights
String lights, lit decorations, and landscape lights run for hours in the dark months. Swap incandescent strings for LED strings as the old ones fail, put them on a timer, and keep the display small. Lighting the holidays with less energy goes into detail.
The first step
Walk through the house and find the light that is on the most hours each day. For many families it is the kitchen or the hallway. Put an LED in it this week. Then replace the rest as they burn out, and start the habit of lights-out with the kids.
Keep reading
Related guides
- Home
How to cool your family home in summer with less carbon
Air conditioning is the biggest summer energy user in most homes. These changes keep kids cool and lower the carbon, from shade and fans to the thermostat.
- Home
How to cut standby power from the gadgets in a family home
Dozens of gadgets draw power all night in a family home. Find the worst ones, cut them off with a power strip, and change the settings that matter.
- Home
How to keep a family home warm with curtains, rugs, and draft stoppers
Heat leaks out through windows, bare floors, and gaps under doors. Curtains, rugs, and draft stoppers keep it in, and most of them need no tools at all.