Carbon Moms

Articles › Home

How to cut hot water use and carbon in a family home

Lower the carbon from your family's hot water with a lower tank setting, shorter showers, a low-flow showerhead, better bath habits, and a heat pump heater.

By Mary Jane HowiePublished 2026-11-116 min read


Hot water is one of the larger energy uses in a home with kids. Baths, showers, dishes, and laundry all pull from the same tank. Every gallon that gets heated burns gas or uses electricity, and both carry carbon.

The good news is that most of the savings come from small habits and a few cheap fixes. This guide starts with the free changes and ends with the bigger purchase.

Lower the water heater temperature

Many water heaters ship set to 140°F. The U.S. Department of Energy suggests 120°F for most homes. That is hot enough for a bath and a dishwasher, and it uses less energy to hold the tank at that temperature.

The lower setting also protects your kids. Water at 140°F can scald a child in seconds. Water at 120°F gives a few more seconds to pull a hand away.

Check the dial on the tank or the settings panel. Check your dishwasher manual too, since some models want 120°F as well. If anyone in the house has a health condition, ask a doctor before you lower the setting.

Shorten the shower

A shower uses less water than a full bath when it stays short. A long shower does not. Kids who play in the shower can run the tank dry.

Try these:

  • Buy a waterproof shower timer, or play one song and call time when it ends.
  • Turn the water off while kids soap up and back on to rinse.
  • Set a family goal, like five minutes for older kids.

Teenagers are the hardest case. Skip the lecture and use the timer. A shower that is a few minutes shorter, repeated every day, adds up.

What goes on in the shower matters too. Cutting the plastic and carbon from your shower routine covers the bottles and the habits.

Install a low-flow showerhead

A low-flow showerhead is the cheapest upgrade in this guide. Federal rules cap new showerheads at 2.5 gallons per minute. Showerheads with the EPA WaterSense label use no more than 2.0 gallons per minute. Older heads in rental homes and older houses may flow faster.

To test yours, hold a bucket under the shower for 20 seconds. Measure the water and multiply by three. That gives the gallons per minute. If the number is above 2.5, swap the head.

A handheld model with an off switch on the handle helps with kids. It makes rinsing hair easy and lets you pause the water.

Rethink bath night

Bath habits vary a lot from family to family. A few ideas help without taking away the bedtime routine.

Bathe siblings back to back in the same water. Fill the tub only as high as the child needs. For a baby or toddler, a few inches is enough, and it is also safer.

Many school-age kids do not need a full bath every day. Ask your pediatrician what fits your child’s skin and activity level. On the off days, a quick wash of the face, hands, and feet works for many kids. Skip the bubble bath on those nights too, since the tub takes longer to rinse.

The rest of the bathroom follows. A lower-carbon family bathroom routine covers toilets, towels, and the products on the counter.

Stop waiting for the water to warm up

Water sits in the pipes between the heater and the tap. Each time someone runs the tap to wait for hot water, the cool water goes down the drain. In a house with kids, this happens many times a day.

Catch that cool water in a bucket or a watering can. Use it on houseplants or the garden. It also helps to turn on the tap only when the child is ready to use the water, not while they look for the soap.

If your hot water pipes run through a cold basement or crawl space, wrap them with foam pipe insulation. It costs little and takes an afternoon. Hot water arrives faster, and less heat leaks from the pipe.

Fix drips

A dripping hot water tap wastes both water and the energy used to heat it. Most drips come from a worn washer or cartridge inside the faucet. Replacing one is a common home repair, and parts are cheap at a hardware store. Check under sinks and around the tub spout too.

With several kids in the house, water use adds up in a dozen small places. Using less water with four kids in the house lists them.

Wash dishes and clothes with less hot water

Run the dishwasher only when it is full. Many ENERGY STAR dishwashers use less water than washing the same load by hand, especially if you rinse under a running tap. Scrape plates and skip the pre-rinse.

For clothes, cold water works for most kid laundry. Our guide to cutting the carbon from family laundry covers detergent, load size, and drying.

Washing less often helps too. Jeans, sweatshirts, and pajamas can often go another day or two. Muddy clothes and anything with sweat or stains still go in the wash. If you buy clothes for growing kids, our guide to buying secondhand kids’ clothes shows another way to cut carbon.

Running the dishwasher with less energy settles the sink-or-machine question and the settings that matter.

Turn the heater down when you are away

If the family leaves for a week, set the water heater to vacation mode or its lowest setting. Many gas heaters have a vacation setting on the dial. Electric heaters can be switched off at the breaker. Switch it back on when you return and give the tank time to heat before the first bath.

For everyday savings, a tank wrap can help an older tank that feels warm to the touch. Check the manual first. Gas and some electric models need clear space around vents and controls. Newer tanks often come with enough insulation already.

Choose a heat pump water heater when yours wears out

A standard electric tank turns electricity directly into heat. A heat pump water heater moves heat from the surrounding air into the tank. It uses much less electricity to do the same job. It is the lowest-carbon choice for most homes with electric water heating, and a good one if you are replacing a gas tank and your local grid is getting cleaner.

The cost is higher up front. Check for rebates and tax credits from your utility, state, or province before you buy, since programs change. An installer can tell you if your space has the room and airflow the unit needs.

Water heaters often fail with little warning, so plan before yours does. If your tank is more than ten years old, ask a plumber about its condition and your options. A planned swap gives you time to compare models. An emergency swap often means buying whatever is in stock.

If the furnace is due as well, switching to a heat pump covers the whole-house version.

Pair hot water savings with other winter changes

Hot water use rises in cold months, because kids take longer, warmer showers. It is a good time to start. Our guide to heating your family home with less carbon in winter pairs well with the steps above.

Start with the tank setting this week. It takes two minutes. Then buy a shower timer and test your showerhead.

Mary Jane Howie

Civil engineer, mom of four, and the writer behind Carbon Moms. She writes about the changes at home that lower a family's carbon without adding work to the week. More about her.